Locknut DIN 981 KM 2 thread M15x1

Cable set for CVD2B driver
+ contains a power supply cable and an I/O signal cable.

Linear unit CTV 110
ISO7, without keyway
1 Short carriage
Stroke 500mm
Ball screw 16x05
with connection plate
without protection cover

Highly flexible Robot power cable for cable chain
M12 connector
Connector 1: Female connector 5 Pin
180 degrees straight shielded connector

Triple-strand sprocket DRS with hub 10 B-3 5/8x3/8" 18 teeth material steel

Linear unit CTV 145
ISO7, without keyway
1 Long carriage
Stroke 250mm
Ball screw 20x05
without connection plate
with PU protection cover

Clevis DIN 71752 size 8 x 16 right handed steel zinc-plated

Timing belt pulley AT3 material aluminium 20 teeth for belt width 6mm 16 AT3/20-2

Flanged bush similar to DIN 1850-3 V sintered bronze bore 8mm outer diameter 12mm flange diameter 16mm length 8mm

Linear ball bearing KB-ST-V with square flange sealed on both sides for shaft Ø 20mm short version

Adjustable clamping lever type K lever length 78 mm shaft length 30 mm external thread M8 x 25mm

spur gear POM black with hub module 2 45 teeth tooth width 20mm outer diameter 94mm

Welding hub for taper bush 1610 outside diameter 83mm material steel

Spur gear made of steel C45 with hub module 2 37 teeth tooth width 20mm outside diameter 78mm

Timing belt pulley AT5 material aluminium 42 teeth for belt width 25mm 36 AT5/42-2

Taper bush 1610 bore 35mm

Easy PLC with :
Motion axis : 16 (pulse control axis + EtherCAT axis)
Encoder axis : 4 channel encoder axis
Pulse output : 8 x 200KHz
Extension modules : 16
Left side extension 2(Support communication/digital IO/analog IO/TF card/RTC)
Communication Port 1 x EtherCAT, 1 x RS485, Support 2 x RS232 /485 extension and 1 x CAN extension
Protocols : EtherCAT, Serial free protocol, Modbus RTU/ASC, CANlink, CANopen
Program storage 200K step
Data storage : 2Mbyte（128KB non-volatile）
Instruction execution time 20K step / 2ms
Dimensions(WxHxD:mm) 53x100x80
Other interface Type C，TF card(need TF card extension module) CAM and ITP motion Support CAM and interpolation motion
Built in IO : 8 input / 8 output
Programming language LD、SFC、FB/FC(support encryption functionality), ST(under development)
Power input DC24V

Chain coupling type 6018 12 A-2 18 teeth nominal torque 630 Nm with casing

Lockwasher DIN 5406 MB2 zinc plated inner diameter 15mm

Can-stack stepper linear actuator