Guides linéaires
Description
In DIN ISO 10285, the dimensions, tolerances and terms of sleeve type linear ball bearings are described in the series 1, 3 and 5.
ISO Series 1: Compact range. In relation to the shaft diameter, the outer diameter and length are smaller than ISO series 3. The load rating is also lower. This range is normally used only in closed design.
ISO Series 3: Medium Range. In relation to the shaft diameter, the outer diameter and length are larger than ISO series 1. The load rating is also higher. This range is the most commonly used, in closed design and also in open design.
ISO Series 5: Rarely used range.
Depending on the shaft diameter, the outer diameter and/or length
are larger, same or smaller than ISO series 1 or 3. And at some
sizes, the grooves for retaining rings and their distances to each
other are different.
Quelques produits dans cette catégorie
| Products | ||
|---|---|---|
|
64901255
Maedler Slide set DZ 3832 slide length 550mm zinc plated |
|
|
64901260
Maedler Slide set DZ 3832 slide length 600mm zinc plated |
|
|
64901265
Maedler Slide set DZ 3832 slide length 650mm zinc plated |
|
|
64901270
Maedler Slide set DZ 3832 slide length 700mm zinc plated |
|
| Products | Description | IMAGE |
|---|---|---|
U wenst meer info te zien?
Actintime ondersteunt enkel professionele gebruikers. Bent u particulier? De fabrikant van uw toepassing beschikt waarschijnlijk over de nodige onderdelen. We raden dan ook aan rechtstreeks contact met de fabrikant op te nemen.